Adding APN

📱Here's a step-by-step guide for adding the APN V5GA01INTERNET for Nomad Omen, Nomad Air, and Raptor devices:

Step-by-Step Guide for Adding APN: V5GA01INTERNET

For Nomad Omen:

  1. Power on the device and ensure it is connected to a computer or smartphone via Wi-Fi or Ethernet.🔌

  2. Open a web browser and type the device's IP address (usually 192.168.1.1 or 192.168.0.1) into the address bar. Press Enter.🌐

  3. Log in to the router interface using the default login credentials or your custom login credentials (proceed by entering the admin password of the device mentioned on the bottom sticker). 🔑

  4. Navigate to “Network” or “Cellular” settings (this can vary based on firmware).⚙️

  5. Look for Continue -> SIM -> Edit -> Add APN ->. ➕

  6. Add a new APN by selecting the option to create or edit the APN settings.

  7. In the APN field, enter V5GA01INTERNET. 📶

  8. Leave other settings (like MCC, MNC, and Authentication) as they are, unless your carrier specifies changes.

  9. Save your settings and reboot the device if prompted. 💾

  10. Check for internet connectivity after the reboot.🌍

For Nomad Air:

  1. Turn on your Nomad Air and connect it to your computer or mobile device. 🔋

  2. Open a web browser and enter the router’s IP address into the browser (192.168.100.1 or similar) and press Enter. 🌐

  3. Log in to the router interface using the default login credentials or your custom login credentials (proceed by entering the admin password of the device mentioned on the bottom sticker). 🔑

  4. Navigate to “Network” or “Cellular” settings (this can vary based on firmware). ⚙️

  5. Look for Continue -> SIM -> Edit -> Add APN ->. ➕

  6. Find and select the "APN Settings" option.

  7. Create a new APN profile by entering V5GA01INTERNET in the APN field. 📡

  8. Leave any other settings unchanged unless instructed by your carrier.

  9. Click Save to apply the new settings. 💾

  10. Reboot your device if necessary, or wait for it to automatically reconnect.

  11. Test the connection by accessing a website or checking your device’s status page for an active connection.

For Nomad Raptor:

  1. Switch on the Raptor device and connect it to your computer or smartphone.

  2. Launch a web browser and enter the Raptor’s IP address (commonly 192.168.1.1 or 192.168.10.1).

  3. Log in using the default credentials (usually both username and password are admin unless changed).

  4. Log in to the router interface using the default login credentials or your custom login credentials (proceed by entering the admin password of the device mentioned on the bottom sticker).

  5. Navigate to “Network” or “Cellular” settings (this can vary based on firmware).

  6. Look for Continue -> SIM -> Edit -> Add APN ->.

  7. Click on Add New APN or Edit Current APN.

  8. In the APN field, type V5GA01INTERNET.

  9. Ensure no other changes are made unless provided by your carrier (e.g., MCC/MNC values).

  10. Save the settings and allow the device to reboot or reconnect.

  11. Confirm that the device is online by testing internet access or checking its connection status.